#Samsung clp 315 printer cleaning windows 10
P.S- If you enjoyed reading this, click here to subscribe to my blog (free subscription). Operating System: Microsoft Windows 10 (64-bit) Recently my Samsung CLP-315W laser printer has started printing with a faint echo of the image about two thirds further down the page (with the echo of the bottom of the image rolling over onto the top of the page). Please give a support by clicking on the social buttons below. This article was prepared for you by Christian Robert Adzic from Novi Knezevac-Serbia The repairing was done and the customer was very happy. Glued it together with a double sided duck tape on the back side of the pcb so I got some extra mm of thickness.Īfter that I glued back to the toner and now it was aligned! Now when I closed the door there were no more light goes On and the error light was off. I cut a piece of cardboard so it fit the dimension of the pcb. When I aligned the chips and close the door I had to push the door to make a contact. So I decided to do the followings: The Samsung CLP-315W is a fancy looking wireless laser printer with a clean design and small footprint, but the output quality is unacceptable and the blisteringly slow speeds will have you. The printer then will shows an error message.Īnother big problem, the chips was to inserted too deep into the toner case. If this is not alligned then the contact can’t be made with the reader electronic and the chip could not be read.
The vertical red lines are the position where the white arrows should be alligned on the toners. All the chip’s on the toner’s was missaligned and the toners was not original from Samsung. When I opened the front door I saw a huge problem. I decided to check the toners and all the stuff which is in charge to read the condition of the toner. A customer brought to me a Samsung CLP-315 color laser printer with the problem “ the printer refuse to use the new installed toners.” The problem is specific because sometimes all the control lights were On and sometimes only one or two lights would be turning On and off. This was a bit strange to me and I decided to try repair the printer.